To keep your Vapodil on top!

To keep your Vapodil at its best, it’s good to keep in mind some good practices … and drop the bad ones!

But before doing so, it is important to take note of the

Prerequisites for use and cleaning procedure VAPODIL 3 2019

• Put washing-up liquid on the O-rings of the handle every time you use it and every time you fill the tank: this will allow you to remove the accessories very easily and to protect the seals;

• Once a month, rinse the tank with clear water: this will remove the beginning of limescale deposits and other impurities from the water;

•  Every 20 uses, put water in the tank, add half a glass of white vinegar, heat it up, turn it off and leave it for 6 hours. Then, empty and rinse the tank twice with clear water;

• Remember to place a label on your Vapodil with the date you last descaled it, so that you can maintain the tank regularly: time goes by so quickly!

• Do not place it high up (e.g. for filling): the weight of the hose and power cord could drop the Vapodil and thus damage it!

• Do not put vinegar in the tank and “spray” vinegared water: this will damage the system and the hose will become porous;

• Do not rub or press any of the accessories used: it is the 120° steam that works for you;

• Do not leave water in the Vapodil for more than a month without using it: this would allow limescale to settle and rot the water, which would generate bad smells;

• Do not pull on the hose to move it during use, move it while transporting it;

• Do not clean the silicone gaskets in direct contact with the sprayer (the burning brass tip would damage them): remember to add the small black round brush;

• Do not wrap the hose too tightly around the Vapodil while it is still hot. At the base of the Vapodil, the hose should be “straight” for 10 cm.

• Do not lend your Vapodil… because not or badly trained, the people you lend it to may misuse it and possibly damage it.